Distribution Joint and Termination Installation | Compulsory Awareness Training

Choices for approved distribution joint and termination equipment are changing to Elcon Megarad and Cooper Power System products to be distributed by DT Jointing Solutions.

The New Standard will apply from 1 March 2018 with full ASP compliance required by 1 July 2018. Compulsory awareness training for cable jointers will be provided free of charge by Essential Energy at central locations across NSW between 8 February 2018 and 2 March 2018.

What’s changing

As part of Essential Energy’s continuous improvement program for asset management, aimed at ensuring long-term reliability and cost efficiencies for customers, we are making changes to the choice of distribution joint and termination equipment installed on our network.

From 1 March 2018, a new Standard will apply which means only Elcon Megarad and Cooper Power Systems products for 95-240mm XLPE cables distributed by DT Jointing Solutions Pty Ltd will be compliant on the Essential Energy distribution network.

Full compliance with the new Standard will then be mandatory from 1 July 2018. This means that any distribution joint and/or termination equipment installed on Essential Energy’s network (or on an asset that is gifted to Essential Energy) must be compliant with the new Standard and be fitted by a cable jointer who has attended awareness training.

We appreciate ASPs cooperation in delivering this important change for customers. If awareness training has not been completed, Essential Energy will deem the installation as a defect and the works cannot be commissioned.

Free compulsory training sessions

The following training sessions will be available at no cost to you. Alternative sessions can be arranged at 5/13 Gibbons Road, West Gosford. These alternative sessions will be at your own expense (approximately $490 per person, depending on timing and attendee numbers).

***** Insert of picture not working *****

The awareness training will provide information about the following equipment:

• 95-240mm XLPE Straight Joint;
• 95-240mm XLPE Outdoor Termination;
• Tee Connector;
• A new heat shrink LV Joint and Termination; and
• New Quick Response (QR) Code systems.

(Please note, these sessions will not provide general training for new cable jointers.)

What you need to bring to your session

Please wear appropriate personal protective clothing. Lunch will be provided as there will be no time to leave the site during the training.

Operating manuals

The change will be reflected in the following operating manuals (available at www.essentialenergy.com.au):

• CEOM7004 - Material Inventory: Contestability (Approved)
• CEOM7204.16 - Shorting and Capping of Underground Cables
• CEOM7204.64 - 11/22kV Termination Components
• CEOM7204.66 - HV XLPE-HDPE 3 Core Straight Joints
• CEOM7204.68 - 11-33kV Outdoor XLPE Terminations
• CEOM7204.70 - 11/22kV Bushing Components

All previously approved components (including those currently in use) will be removed from these manuals from 1 March 2018.

Bookings and further information

For session bookings and further information please contact:

David Taylor
DT Jointing Solutions Pty Ltd
18 Zakwell Court, Coolaroo VIC 3048
T: 0401 487 979
E: eeasp@dtjointingsolutions.com.au

Or

Daniel Kelly
Essential Energy
T: 02 6589 8623
E: daniel.kelly@essentialenergy.com.au